We have just been approved for field use for launching model rockets at the WyEast Middle School and there are a couple of days where we can also launch at the Westside School ( to support rocket build and Hood River Hobbies)
The dates are the following:
August 2016
August 7th (Football Field) 9 am to 12 pm WyEast (Permit #1607-0003)
August 27th (Middle Soccer Field) 9 am to 12 pm WyEast (Permit #1607-0003)
September 2016
September 10th (Middle Soccer Field) 9 am to 12 pm WyEast (Permit #1607-0003)
Sat September 17th, 10:30-12:00 Introduction to Rocketry and build a rocket at Hood River Hobbies. 1pm Launch at Westside School
September 25th (Football Field) 9 am to 12 pm WyEast (Permit #1607-0003)
October 2016
October 1st (Middle Soccer Field) 9 am to 12 pm Hood River Hobbies participants at 10 am WyEast (Permit #1607-0003)
October 23rd (Football Field) 9am to 12 pm Hood River Hobbies participants at 10 am WyEast (Permit #1607-0003)
November 2016
November 5th (Football Field) 9 am to 12 pm Hood River Hobbies participants at 10 am WyEast (Permit #1607-0003)
Saturday Nov 19th – 11am Introduction to rocketry and build a rocket at Hood River Hobbies
Thursday Nov 24th- Thanksgiving rocket launch Westside School 10am
November 27th (Football Field) 9 am to 12 pm WyEast (Permit #1607-0003)
December 2016
December 3rd (Football Field) 9 am to 12 pm WyEast (Permit #1607-0003)
December 18th (Football Field) 9 am to 12 pm WyEast (Permit #1607-0003)
Saturday Dec 31 New Years Eve rocket building class at Hood River Hobbies 10:30am New Year’s Eve rocket launch at Westside School 1pm
***PRE-FLIGHT PROCEDURES***
THE ROCKETEER WILL:
- Construct the rocket using adequate levels of craftsmanship and materials;
- Perform calculations and/or simulations to assure performance for the given flight configuration to assure proper CP (Center Of Pressure) to CG (Center of Gravity) relationship for the given flight configuration. This is only necessary for scratch-built rockets or modified kits;
- Have the CP and CG marked on the rocket (not necessary for unmodified kits);
- Properly select, assemble and install the motor;
- Test any electronics used in the recovery system;
- Ground test the recovery system – perform live ejection charge tests for the given flight configuration and any time the rocket configuration is changed;
- Fill out a launch card;
- Present himself/herself and the rocket to be flown at the RSO table when ready to fly;
- Execute the RSO’s preflight procedure – SEE/REF RSO CHECKLIST;
- Be prepared to answer any questions the RSO may have about the rocket at the preflight safety check;
- Fill out the launch log;
- Confirm the pad and personnel positions are correct in relation to the projected flight path;
- In coordination with and approval from the LCO proceed to pad and ready rocket to fly;
- Confirm launch rod/rail alignment is correct for conditions;
- Arm and confirm flight electronics after rocket is upright on rail;
- Install igniter after electronics armed and rocket on rail (not required for most model rockets);
- Arm pad launch circuit;
- Upon approval from the LCO, proceed to launch the rocket;
- Perform range and sky checks at T-Minus 30 seconds;
- Perform final range and sky check at T-Minus 10 seconds;
- Arm launch controller at T-Minus 10 seconds;
- Begin Countdown at T–Minus 5 seconds;
- Start ignition at T– Minus 1 second;
THE RSO WILL:
At the RSO table;
- Physically inspect the rocket for construction integrity
- Assure CG and CP are marked on the rocket
- Inspect the recovery system; shock cord, hardware, and parachute
- Ask the rocketeer about the motor; proper selection, proper loading/construction process
- Perform CG check
- Ask any questions the RSO deems prudent
- Check the rocketeer’s launch card and fill out appropriate parts
- Ascertain the rocketeer understands launch process and range safety procedures
- Assure launch pad alignment is safe for given wind conditions and personnel location
- Communicate a GO/NO GO to the Launch Controller
- In coordination with the LCO, assign a launch pad
THE LAUNCH CONTROLLER WILL:
- Alert all personnel that a launch is imminent
- Assure recovery personnel are at standby Perform a sky check
- Perform a range clear check
- Work with rocketeer to perform the launch
EVERYBODY WILL:
- PAY ATTENTION WHILE LAUNCH OPERATIONS ARE ONGOING!
- Act as safety monitors – safety is EVERYBODYs business – call “KNOCK IT OFF” if you see a safety issue
- Assist in tracking the rocket upon launch
- Follow the directions of the RSO and LCO
IF ANY OF THE PRECEDING CONDITIONS ARE NOT MET – THE ROCKET WILL NOT FLY UNTIL THE DISCREPANCIES ARE CORRECTED AND THE RSO RE-INSPECTS AND APPROVES FOR FLIGHT!